For an existing roof opening panel motor skip to step 3.
Roof opening panel motor initialization.
For a new roof opening panel motor proceed to step 2.
The roof opening panel motor initialization procedure must be done when repairs are carried out on part of the roof opening panel system including.
The roof opening panel motor s must be initialized when repairs are carried out on any part of the roof opening panel system including whenever the roof opening sliding glass or power shade motor has been removed from the roof opening panel system.
Assembly a new roof opening panel motor has been installed or when a new roof opening panel assembly has been installed.
If the slide switch is released before initialization movements are complete turn the ignition key to the off position then back to the run position and repeat this step.
The roof opening panel glass has been removed from the roof opening panel system.
The initialization movements will start within approximately 3 seconds after the switch is pressed.
Any time the roof opening panel motor has been removed from the roof opening panel assembly a new roof opening panel motor has been installed or when a new roof opening panel assembly has been installed.
The roof opening panel assembly has been removed from the vehicle.
Quickly release and re press and hold the slide switch.
For a new roof opening panel motor.
The roof opening panel will cycle slightly rearward and then slightly forward to the stored open position.
If your sunroof is broken or making a popping snapping noise this won t f.
A new roof opening sliding glass or power shade motor has been installed.
The roof opening panel glass will move to the full vent position then back to closed initialization movements.
2017 escape vehicles equipped with power roof opening panel built on 06 jun 2016 and through 03 dec 2016 have a change to the initialization procedure for both the roof opening panel and the shield sunshade.
Refer to workshop manual section 501 17.